Q&A: How Aircraft Carrier Catapults Work

Question: I know an F-18 Hornet needs about a mile of ground runway to take off. So how can they launch from aircraft carriers that only have 500 feet of runway? — WW, Kitty Hawk, NC

Answer: Watch the video closely and you’ll see something attached to the front wheels of the F-18. It’s called a shuttle and is connected to a steam powered system that helps accelerate the F-18 much faster than its engines alone could do.  An F-18 needs around 180 mph (80 m/s) of airspeed to take off. With 500 feet (150 m) of runway that will require an acceleration of:

a = (VF2 − VO2) / 2d = [(80 m/s)2 − (0 m/s)2] / 2 × 150 m = 21 m/s2 (2.1 g’s!)

The empty weight of the F/A-18 Hornet is 23,050 lbs. The gross weight is 36,410 lb for a fighter mission and 51,900 lb for an attack mission. We’ll use 50,000 lb (23,000 kg) for this calculation. With that mass, to reach a speed of 80 m/s in 150 m requires a force of:

F = ma = 23,000 kg × 21 m/s2 = 483,000 N (109,000 lb) of thrust.

The F-18’s two engines can produce 160,000 N (36,000 lb) of thrust, which provides an acceleration of:

a = F/m = 160,000 N / 23,000 kg = 6.9 m/s2

so with a 150 m runway, running on engines alone, it could only attain a speed of:

VF = √2ad = √(2 × 6.9 m/s2 × 150 m) = 45 m/s

before it reaches the bow of the carrier, 35 m/s short of its minimum airspeed. Of course, if the carrier is moving straight into a headwind that can add 35 m/s to the relative airspeed, then all systems are go. The maximum speed of a carrier is around 16 m/s, so you’d only need an ambient wind of 19 m/s (43 mph). But in a combat situation, tactical maneuvers may render this unfeasible. Clearly, we need more thrust.

And that’s where the steam catapult comes in. Fighters that launch from carriers get an assist to their engines from a mechanical system using steam power to provide additional thrust. It’s basically a huge piston and cylinder that attaches temporarily to the fighter and provides the needed additional 323,000 N of thrust. That’s twice what the jet engines alone could provide. Still, to reach the speed needed for launch, the jet needs to bring its engines to full thrust an instant before the catapult fires. That why they need a blast shield on the deck. Here’s a simplified block diagram of how the catapult works:

The system is over-engineered to provide sufficient acceleration regardless of wind speed or direction. Flexibility is the key to design. The carrier strike group surrounding it can maneuver quickly, allowing aircraft to launch in any direction.

Here’s a photo showing an F-18 Hornet at the moment of launch. Note how the front gear is already above the level of the deck. Lift exceeds weight. This is a successful launch:

When sufficient airspeed is not attained due to mechanical failure in the catapult or jet engines, the pilot can decide to land in the water (the F-18 will float, and retrieval cranes are standard equipment on carriers), or in a worst case scenario the pilot might decide to eject, in which case the jet (minus canopy) is at risk of sinking. Overall, carrier launch failures happen less than 1% of the time. This is a result of good design, regular maintenance, and professional crews.

The Navy is currently investigating a replacement for steam catapults employing a rail gun instead. The official name is Electromagnetic Aircraft Launch System (EMALS). The first was installed on the USS Gerald R. Ford in 2015. It’s still being tested, but has already demonstrated faster recharge times and greater efficiency compared to steam catapults. Carriers built in future decades will likely use EMALS.

Next Week in Sky Lights ⇒ The Edge of a Stratus Cloud

Formation of the Strait of Gibraltar
The Edge of a Stratus Cloud
HOME